Surface chemical analysis. Depth profiling. Measurement of sputtering rate. Mesh-replica method using a mechanical stylus profilometer Ingestion-build-225643 — railways with different track

— railways with different track layout

NOTE Mechanical mixing valves for use at pressures in excess than those in Table 1 are covered by EN 817

boilers with a maximum pressure rating of 2 000 kPA (20 bar) and equipment for general household and similar use including controls for heating

BS 3016:1989

Surface chemical analysis. Depth profiling. Measurement of sputtering rate. Mesh-replica method using a mechanical stylus profilometer Ingestion-build-225643 — railways with different track1 Scope This Technical Report describes a method for determining ion sputtering rates for depth profiling measurements with Auger electron spectroscopy (AES) and X ray photoelectron spectroscopy (XPS) where the specimen is ion sputtered over a region with an area between 0,4 mm2 and 3,0 mm2. This Technical Report is applicable only to a laterally homogeneous bulk or single layered material where the ion sputtering rate is determined from the sputtered